Emulex UC17/UC18 SCSI-Controller in PDP11/24

Gooijen H GOOI at oce.nl
Mon Jun 13 02:53:29 CDT 2005


  Hello Andreas,

you might try leave off the leading "17" of the address,
thus enter @760334 1 <LF>  but I am not 100% sure.
Give it a try :~)

- Henk, PA8PDP.


> -----Original Message-----
> From: cctalk-bounces at classiccmp.org
> [mailto:cctalk-bounces at classiccmp.org]On Behalf Of Andreas Holz
> Sent: maandag 13 juni 2005 8:58
> To: On-Topic and Off-Topic Posts
> Subject: Emulex UC17/UC18 SCSI-Controller in PDP11/24
> 
> 
> Hello all,
> 
> I'm trying to configure an Emulex UC18 SCSI-Controller in a PDP11/24.
> 
>  From the switch settings (MSCP) the Device Base Adresses of the two 
> SCSI channels are 17772150 and 17760334.
> 
> Looking at the UC17 Manual (bitsavers) on page "Installation 4-33" I 
> found to enter the following at the 11/24 ODT prompt:
> 
> @177xxxxx 1 <LF>
> /177yyyyy 30003 <CR>
> 
> ...
> 
> based on the real adresses e.g.:
> 
> from table 4-13 on page 4-31 xxxxx = 60334 and yyyyy = 60336
> 
> @17760334 1 <LF> -> but how to enter such a long adress on a 11/24?
> 
> What is going wrong?
> 
> Andreas
> 




More information about the cctalk mailing list