RX01 felt pad (Tim)

Allison ajp166 at bellatlantic.net
Tue Oct 25 18:37:34 CDT 2005


>
>Subject: Re: RX01 felt pad (Tim)
>   From: David Gesswein <djg at drs-c4i.com>
>   Date: Tue, 25 Oct 2005 18:22:26 -0400
>     To: cctalk at classiccmp.org
>
>   I just took apart my RX02 to clean them since they were getting
>flakey.  On a previous drive I just went to a craft store and bought the
>closest material I could find, cut it to a small dot to fit in the
>cup. Put a drop of glue in the cup and push the material in. 
>
>To get the drive out for access.
>1) Remove from outer shell if you have the desktop unit.  The top cover
>comes off with obvious screws then ones along the side free the internal
>unit.
>2) Disconnect the cables to the controller board and motor power connector
>on the back of the drive hidden by the air baffle.
>3) Remove drive from rest of assembly.  2 screws through the air baffle
>at the back and 4 from the top down.  If you tilt the upper board up
>on the hinge they are accesible through holes in the lower PCB.  
>
>That should free the drive.  You can then lift up the little presure arm
>to easly get at the pad.
>
>I don't have any real RX01's so they might be slightly different for
>disassembly.

RX01 drives and RX02 drives are the same.  Only the logic differs.


Allison



More information about the cctalk mailing list