RK07 questions

[Gooijen, Henk]

> No, it's not 'just like the RL01'. The RL's have embedded 
> servo bursts -- tht is there are servo signals in the sector 
> header regions of each data surface. The same head reads the 
> servo signals and the data.

Correct again Tony :-)  My mistake.

> The RK07 has a seperate servo surface. There are 4 surfaces 
> (2 platters) in the pack. One surface and its head is just 
> servo signals. The other 3 surfaces are just user data (and 
> sector headers, etc). 

That's what I've read too.
Just a stupid mistake to compare the RK07 with the RL02.

> Ah, right.... Remember I am a hardware person and deal with 
> gates and op-amps :-)

Yep, I know!

> OK. It sounds like your drive is basically working. What I'd 
> do at this point is look at the prints to see what should 
> drive the ready lamp. And then check back from the output 
> stage until you can find out why it's not being turned on. I 
> can dig out my prints and take a look too.

That's exactly what I intend to do :-)  but I will first have
a look on the behaviour of the other two drives, while I'm at it.

  thanks,
- Henk.

This message and attachment(s) are intended solely for the use of the addressee and may contain information that is privileged, confidential or otherwise exempt from disclosure under applicable law.  
If you are not the intended recipient or agent thereof responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this communication is strictly prohibited.  
If you have received this communication in error, please notify the sender immediately by telephone and with a "reply" message.  
Thank you for your cooperation.