Power plug for a VAX 4000-300

[Rod Smallwood]

Hi
  I managed to find a slim one that fits and the door shuts!!! 

Rod Smallwood

DecCollector


-----Original Message-----
From: cctech-bounces at classiccmp.org
[mailto:cctech-bounces at classiccmp.org] On Behalf Of arcarlini at iee.org
Sent: 31 May 2007 22:11
To: 'General Discussion: On-Topic and Off-Topic Posts'; 'General
Discussion: On-Topic Posts Only'
Subject: RE: Power plug for a VAX 4000-300

Rod Smallwood wrote:
> So whilst what I have will probably run, its not the correct cable.
> It should be a right angled IEC type with a groove or slot opposite 
> the middle pin.

The right angle is needed only if you want to shut the front door.
If you don't have a right angle one, you either leave the door open or
remove it (it comes off very easily ... it becomes lost very easily too
:-))

Antonio