QUME DT/8 - anyone have a manual/schematic for this?
cclist at sydex.com
Tue Oct 28 18:53:28 CDT 2008
On 28 Oct 2008 at 16:23, Rick Bensene wrote:
> Is there a difference between a QT-8 and (what the original poster asked
> about) the DT-8? I know that the DT-8 was a double-sided,
> double-density drive.
The Bitsavers docs for the 842 identifies the 842 as the "Datatrak
My own drives are labeled as "QumeTrak 842", but match the (full-
height) drives described in the aforementioned (DT-8) document
perfectly. It could be that Qume models had a name change sometime
around 1980 or so.
The QumeTrak 242 is the half-height 8", but I don't believe it was
ever referred to as a "DataTrak 8". It used a DC spindle motor and
did not have native hard-sector (i.e. sector output and 32/16/8
sector selection; also, no optional on-board FM data separator.) As
far as built-like-a-battleship-ness goes, a poor relative to its full-
height 842 cousin. But if the OP has the 242, there's a document for
it also on bitsavers.
More information about the cctalk