Advice for Tek 4051 vector-drawing issue?

[Philip Pemberton]

Tony Duell wrote:
> If this were my system,. I think I'd modify that 8050 to ignore IFC.

Personally, I'd sooner get a couple of IDC IEEE-488 connectors and some cable, 
crimp the connectors on the cable (wired 1-1, 2-2, etc.) then separate the IFC 
wire from the rest of the bundle (I'd pick a bit in the middle, say 2in long). 
Cut that wire dead in half, continuity-check the cable, then cut the IFC wire 
down to a more respectable length once all the checks pass (or solder it back 
together if it turns out you cut the wrong wire).

-- 
Phil.
classiccmp at philpem.me.uk
http://www.philpem.me.uk/