NCCC - Sunfire V100 / Solaris

[David Holland]

According to the documentation here:

http://dlc.sun.com/pdf/819-1160-13/819-1160-13.pdf

the default password after twiddling the jumper is.... 

changeme

David


On Fri, 2009-01-09 at 10:55 -0600, Tom Uban wrote:
> Sorry about the lack of true classic computing content to this
> question, but it does relate to a little bit older machine, a
> Sunfire V100...
> 
> I purchased one of these from eBay in hopes of possibly upgrading
> my home firewall and discovered that the machine has a Lights-Out-
> Management (LOM) CPU controlling the main UltraSPARC IIi processor.
> The LOM runs a monitor program (LOMlite) which on this particular
> machine is currently configured to require a login/password when
> communicating with the machine over the console serial port.
> 
> >From seemingly endless google searching, it sounds like I should be
> able to break out of the LOMlite login/password cycle by resetting
> the machine with the JP13 jumper. When I do this, LOM is reset, a
> few seemingly ok diagnostic messages are emitted, and then the login
> password are again requested.
> 
> I was unable to determine if there is some sort of default login
> password.
> 
> The only path seems to be to possibly load the PATA IDE hard drive
> with Solaris, and then use the Solaris tools to reset the LOM setup.
> 
> Does anyone on this list have any experience with this machine?
> 
> --tnx
> --tom