Doing DU0 bootable with RT11 5.3 from one TU58
spedraja at ono.com
Fri Jun 19 01:27:49 CDT 2009
Thank you, David. The information is correct. I installed succesfully RT11
5.3 in the ESDI drive. And, by now, at least can start my PDP-11/23 PLUS
with one Operating System :-)
Complementing previous information, the system has (by now) 2044Kw (4Mb) of
memory in a couple of memory boards, and one Dilog DQ696 with its own setup
ROM in 175000. This is important, because I can't bootstrap the DU (by now
too) from the "START?" prompt of the PDP-11/23 PLUS and I must do it from
the ODT prompt with this sequence:
If I've read my manuals correctly I think that is possible to automate this
with switches in the DQ696 and the PDP cpu and front panel.
I leave the previous messages below of this answer for someone that want to
use it for configuration purposes.
Thanks again. Regards.
2009/6/18 Dave McGuire <mcguire at neurotica.com>
> On Jun 18, 2009, at 5:18 PM, SPC wrote:
>> I started one virtual TU58 with RT11 5.3 from the COM1 of my laptop in my
>> PDP-11/23 PLUS using TU58EM.
>> In the same machine I have one DILOG DQ696 with one ESDI hard drive of 768
>> Mb. I want to convert the ESDI drive in a bootable device with RT11.
>> I've initialized the DU0 and copied the complete system from the DD0
>> Searching for the fast path to continue... Someone knows what must I do
>> exactly now to continue ? Thanks in advance.
> If you're certain the target disk contains DU.SYS (or DUX.SYS as
> appropriate), you'll need to make it bootable. For example, this is how to
> do it using RT11SJ. This is from memory, you may want to double-check the
> syntax in the help system:
> . COPY/BOOT:DU DU0:RT11SJ DU0:
> Dave McGuire
> Port Charlotte, FL
More information about the cctalk