Multimeter recomendations

[Fred Cisin]

On Fri, 24 Sep 2010, Chuck Guzis wrote:
> the technique because of the nature of valve end-caps.  They're
> usually somewhere around 3/4 - 1" in diameter with fine machined
> threads--the danger of cross-threading is great.  However, turning
> the cap anti/counter-clockwise until one hears the "click" ensures
> success.
> I suspect that most plumbers know about this when using fine-thread
> fittings.

MOST plumbing is a relatively coarse thread.


Screw-mount camera lenses. 39mm x 25 tpi.  (39mm x 1mm is a less than
perfect fit.)