diagnosing an Intel Series II MDS monitor failure
spacewar at gmail.com
Sat Aug 1 16:22:39 CDT 2015
On Sat, Aug 1, 2015 at 2:36 PM, Brent Hilpert <hilpert at cs.ubc.ca> wrote:
> Just a suggestion: you're sure there no ground reference problem on pin 7 (V-) of the 723? (hence raising the Vref).
> I've seen small 723-based supplies with sense leads where the 723 V- is on the neg. sense lead rather than neg. output lead.
I checked it, and don't see any offset from ground elsewhere in the circuit.
This particular supply rail doesn't use remote sense. They only use it
on the 5V 30A supply, which is on a different board.
More information about the cctalk