RA-81 issues (Jerry Wright)
michael.99.thompson at gmail.com
Sat Feb 7 14:56:07 CST 2015
> From: Jerry Wright
> Sent: Friday, February 06, 2015 8:54 PM
> Subject: RA-81 issues
> I have a rack full of RA81's, all Pass Rom base self test. If I try to
> up one of the drives, It will start to spin up and then just stop. There
> no front panel lights that come on or codes on the terminal screen. all 3
> drives do the same.
> These are not connected to a controller, and the manual does not say this
> is need.
> The forth one has no drive and the motor seems to turn hard, is there a
> on the motor ???
> - what I'm I missing here
> Thanks Jerry
I have seen two common problems problems with RA-81 drives.
Failure of the motor start capacitor, and failure of the optical sensor on
the bottom of the HDA for spindle speed. With both failures the drive will
start to spin-up, and then spin-down.
You can connect a serial terminal emulator to the DB25 diag connector. Then
you can run internal diagnostics and get the fault codes.
The RICM has several RA-81 drives, all with failed optical sensors.
More information about the cctalk