RL01/02 spindle ground brushes
useddec at gmail.com
Tue Mar 3 21:54:16 CST 2015
Thanks for the info.
On Tue, Mar 3, 2015 at 7:29 PM, Paul Koning <paulkoning at comcast.net> wrote:
> > On Mar 3, 2015, at 8:24 PM, Mark J. Blair <nf6x at nf6x.net> wrote:
> >> On Mar 3, 2015, at 16:56 , Paul Anderson <useddec at gmail.com> wrote:
> >> Do you have a good source for graphite rod? I'm looking for some for
> >> another project.
> > McMaster-Carr carries graphite rod stock.
> So does Enco (use-enco.com), which often is less expensive (but doesn’t
> have quite the enormous selection of stuff that McMaster-Carr does). They
> call it “EDM Rod” because these rods are used for the tool bits in electric
> discharge machines.
More information about the cctalk