VT100 PSU smelling.
mattislind at gmail.com
Sat Jan 23 04:24:01 CST 2016
> Speaking generally, I don't know that that will necessarily save one (in
> using a variac on a SMPS).
I for one think it is a good practice to start carefully. I like the idea
of bringing up the voltage over capacitors and other electronics in a
controlled manner. Electronics that had been sleeping for decades. I use a
protection transformer, variac and also often means to limit the current.
Then I could easily measure how the switching transistor behaves. The
base/gate drive etc.
> A SMPS functions as a constant-power converter in response to varying
> supply voltage. For a given load, as the supply V goes down the supply
> current goes up, to keep the load delivery constant. (This is in contrast
> to linear-regulator supplies which maintain headroom V into the regulator
> and simply limit the output V - the only thing that changes as the supply V
> varies is the headroom V and how much energy is wasted as heat in the
> AIUI, the concern for SMPSs is that if the supply V is too low, the supply
> current and consequent factors may go too high for parts such as the driver
> transistors, etc.
> Whether it's a catastrophe depends on a variety of factors: whether the
> design detects & incorporates shut-down under these conditions, how large
> the load is (how much power the PS is trying to convert) (if the PS is
> lightly loaded relative to it's max capability there may be no problem),
> whether the pulse-width/switching characteristics are wide enough to become
> a problem under low supply V, and so on.
All this depend on what load your are using. When running on the bench with
variac I have a very modest load. In this case 100 mA at full 5V. Just 1 %
of rated output. In that case there is very unlikely to overload the switch
> Supplying an external start-up V would strike me as a crap-shoot,
> dependent on the design of the supply:
> - On the one hand, if the PS was designed so that an
> early-energised control circuit would shut-down
> or limit the main switching under low supply V, then good.
That was the case for the VAX-11/750 supply which didn't enable switching
under low main input conditions. Something I deliberately disabled to be
able to test. In the case of the VAX-11/750 PSU I was able observe and
detect a number of failures in the supply at low and non-harmful voltages.
Regardless of protection transformer or not I don't like the idea of
working with a PSU with 300VDC everywhere when probing with the scope
> - On the other hand, if the PS was designed such that the control
> circuit wouldn't be energised
> by the startup supply until the supply V was in the safe region
> for the main switching, then bad -
> the external startup supply may fool the control into thinking
> the supply V is in the safe region.
But "safe" depend on the load applied to the supply.
On the other hand my question to the list was not if the use of variac is a
good practice or not. I will continue to use this method since it has
served me well and I am not forcing any one else to use it if they feel it
The question I have is why R27 in the snubber network is getting what I
think excessively hot. The schematic for the primary side can be found
One input that I had that if C19 is marginally bad then that might happen.
Like if the dielectric as deteriorated over time and cannot whit-stand the
voltage in the circuit.
The capacitor is not cracked like the RIFA ones. It looks perfectly fine.
It is a SPRAGUE 0.033uF 1600VDC. I don't have an capacitance / ESR meter so
I cannot check it. Maybe I should just go ahead replacing it. But I don't
like idea of replacing things without really knowing they are bad.
Another question is whether the R27 is normally getting hot or not. What is
VT100 owners experience here?
More information about the cctalk