paulkoning at comcast.net
Tue Mar 29 19:25:48 CDT 2016
> On Mar 29, 2016, at 8:18 PM, Guy Sotomayor <ggs at shiresoft.com> wrote:
> I just finished laying out the board for the MEM11A. The last roadblock was figuring out
> where the last 3 unrouted wires were. EagleCAD didn’t make it easy to find them and I
> haven’t quite figured out how to use the autorouter on Eagle 7.5, so I did this all by “hand”
> (at just under 2000 wires it took a while).
I can imagine. Hand-routing tends to produce much better results; the autorouter in EagleCAD isn't all that good. A simple way to find the not yet routed wires is to turn off the metal layers but leave the "ratsnest" layer visible.
More information about the cctalk