Supercomputers, fishing for information

Guy Sotomayor Jr ggs at shiresoft.com
Tue Nov 8 11:08:16 CST 2016


> On Nov 8, 2016, at 8:47 AM, Jon Elson <elson at pico-systems.com> wrote:
> 
> On 11/07/2016 10:31 PM, Jon Elson wrote:
>> On 11/07/2016 07:59 PM, Mark Linimon wrote:
>>> On Mon, Nov 07, 2016 at 11:23:58AM -0800, Chuck Guzis wrote:
>>>> But if you're a suburban resident living on Mulberry Street, anything
>>>> but single-phase is pretty much out of the question.
>>> Oh, you can get it -- but be prepared for a large hassle.
>>> 
>>> A former neighbor had a 440V 3-phase Italian lathe in his backyard shop,
>>> among other toys.  After he was laid off from his aerospace job doing
>>> machining it was how he made his living.  He was a very handy person
>>> to know :-)
>>> 
>>> mcl
>>> 
>> I have two 3-phase machines in my shop (Bridgeport mill and Sheldon lathe) and run them each off a properly-sized VFD. 2-phase in, 3-phase out, plus variable speed and dynamic braking.
>> 
>> Jon
>> 
> And, of course, that is really SINGLE-PHASE power on 2 wires, just to save anybody the trouble of correcting my error.
> 

I’m looking to have to do something to get 3-phase for the IBM 4331 gear.  I haven’t quite added up the power requirements yet but I’m guessing its going to be in the 10-15kVA range.  Since the power to all of the gear is really split between 3 loads (string of 4 3340 drives, 3803 control unit + 2 3420 tape drives and 2821 control uint + 1403 printer + 2540 card reader/punch) I need to figure out if it’s best to have one big converter or 3 smaller ones.  It’s unlikely that I’d be running all of the peripherals at once.  The 4331 itself runs off of single phase 220v.

TTFN - Guy



More information about the cctalk mailing list