ISO: PDP-11/40 LTC and Stack Limit options
billdegnan at gmail.com
Wed Nov 23 09:11:55 CST 2016
>> Interesting. I suppose the LTC on the M7856 could also be disabled...
> I'll have to try that and see if it works. The DL11-W manual doesn't seem
> to cover any special installation procedures for the 11/40, and the 11/40
> System Manual describes Slot 9 as a "SMALL PERIPHERAL CONTROLLER (USUALLY
> DL11)" slot without mentioning the lack of NPG and the LTC oddity. Weird.
> I now have the CPU passing diagnostics with flying colors (there was a
> problem with the IR Decode logic causing incorrect reserved instruction
> traps), and I can boot RT-11 from the SCSI controller, yay. Now to track
> down the EIS and Stack Limit options...
> - Josh
Glad to hear. Also this thread may have given me the clues I need to boot
an RL02 / 11/40 / RT-11.
1) I never thought to check to see if my system was used with a KW11-L in
the past, I too appear to have a CPU set that came from a different
system. I need to check for a missing jumper in slot 3 of the CPU
backplane. F03R2 and F03V2.
2) I actually do have a KW11-L (M787), but whenever I attempt to use it I
can't do much other than toggle memory using the front panel. Simple CPU
programs fail, and I can't boot using M9312. (I actually tried 2 of these
cards, same result) I thus assumed I did not have a CPU backplane wired for
a KW11-L, but it could be that it actually *is* and the problem is with the
M787 card, a fault in the card. I have 0 experience with altering or
testing backplane jumpers, but I will try. I have always used an extender
card instead and probed signals form the extension card as a cheat. It
seems like the NPG is OK AFAICT, but I did not check slot 9. It does not
seem to matter whether I have a grant card in slot 9 or not either.
3) I would not mind getting something like Guy's UA11 to test with. Are
4) I have been also working on getting a M7856 wired to 177560 so I can
emulate a TU58. Made progress last night, will keep working on getting
XXDP running. Up to this point I had been loading in one routine at a time
using PDPGUI. Some success, used to learn my system was expecting a KJ11
(M737), which fortunately I had. Since then I verified that my CPU cards
are correctly jumpered for what I have installed in the backplane. Per
this conversation I believe I have the correct cards and enough working RAM
to operate RT-11.
Noel - Do you ever make a trip up my way? If you ever have time to stop by
to help me with my system I'll trade you some hardware or food for your
More information about the cctalk