PDP-8e power switch key?
jwsmail at jwsss.com
Wed Nov 30 23:17:08 CST 2016
On 11/30/2016 8:35 PM, W2HX wrote:
> Hi folks,
> What are people doing for keys for the 8e? Is there a standard key used for all of them? Or do I need to have one made with some specific serial number of my key lock? I did some googling of this issue but wasn't able to get info.
> Eugene W2HX
Since I'm going to get some keys made, I looked up Jay's posting of
keys, three of which we verified from his formulas.
Here is the posting from March 2016
Here are the formulas he posted then. I thought there were more
discussions about making an archival page, but I did not go on and look
up whether it was made up or not.
As Ethan said, somewhere there is also a 3d print STD file I believe,
but the locksmith numbers are better.
**** key post contents ****
FYI - the key codes I measured previously for Data General and HP have been
cut, tested, and verified. Amazingly, my measurements were correct. So to
Use: DEC PDP-8 (all varieties), PDP-11 machines that do not use an ACE blank
Use: Data General Nova (800,1200,1220,2,3) Eclipse (S/130,S/200)
Use: Hewlett-Packard 2100A/2100S
NOTE: The codes above are listed 7-1, and all key cuts are center offset.
Still unconfirmed or need more information:
Code: (Mike Stein was going to measure his cuts)
Use: Cromemco Systems CS-1/CS-3/CS-100
More information about the cctalk