aaron at aaronsplace.co.uk
Fri Dec 8 12:53:34 CST 2017
> On Fri, Dec 8, 2017 at 3:03 PM, Aaron Jackson <aaron at aaronsplace.co.uk> wrote:
>> Manual says it should be S1=off, S2=on for RX211 and RXV21
> In the photo, I think S1 is on and S2 is off. Check them with an
> ohmmeter if in doubt!
Yes - you are right. I switched them back to how they were when I got
the drive. I think one of the switches was half down because XXDP
actually does something now.
Most of the tests now look something like this:
CZRXFB0 DVC FTL ERR 00034 ON UNIT 00 TST 031 SUB 000 PC: 003476
SECTOR ADR - LGC TST
SECTOR ADDRESS ERROR
I suppose these should match?
Starting to think I might need to confuse myself with my logic analyzer
and the RX02 control board.
More information about the cctalk