jcwelch at hal-pc.org
Thu Dec 14 08:43:00 CST 2017
On 12/14/2017 6:47 AM, Noel Chiappa wrote:
> > From: John Welch
> > CLR
> > 765000
> > LAD
> > EXAM
> > 'Bus Err' light comes on.
> Oooh, that's very interesting, and illuminative. The ROM isn't working (so
> there's no way for the software console to work - its code is in that ROM).
> So look at Section 1.5 of the Technical Manual
Will do. I have 4 M9312 cards. One I know I pulled from an 11/04, the
others from 11/04 or 11/34 (or 11/34a)
> Also, while we're at it, it's probably worth making sure the CPU will
> run. Do this:
> 777 (This is a 'branch .' instruction)
> EXAM (Should display '777')
> CLR (I think you can dispense with these
> LAD two, but just to be safe...)
> 'Run' light should come on
> 'Run' light should go out, should display '0' (or maybe '2', I forget)
It read 000000
> > Do you know which color wire (red, clear, black) goes to which festoon
> > connector (TP1, TP2, TP3, TP4)?
> I would leave them all disconnected for the moment; you don't need them. One
> is the 'boot' switch on the console, and its ground. The other is the 'boot on
> power on enable' (a duplicate of S1-2), and its ground. Since we're trying to
> manually start the ROM console from the front console, they aren't needed for
> I don't recall offhand which one connects to which - I will have to check.
> > Don't want to blow anything up.
> Not sure it will harm anything if you connect things wrongly, but that's
> not tested.
More information about the cctalk