ST-238R and ST-225, likely controller?
cctalk at randy482.com
Thu Mar 10 13:47:22 CST 2005
From: "Ryan Underwood" <nemesis-lists at icequake.net>
Sent: Thursday, March 10, 2005 12:17 PM
> A friend has a ST-238R and ST-225 that came out of his XT long ago.
> We're trying to figure out what the most likely controller that was
> being used in the original machine so we can recover the data. It must
> have been 8-bit and support RLL. The best guess I can come up with is
> the WD 27X (which I used to have). Anyone else have a good guess?
> I think the ST-225 came with the machine and then the ST-238R was
> installed as part of a kit. So whatever controllers were usually sold
> with those as a kit (i.e. from Dirt Cheap or a refurbisher) would be a
> likely candidate too. For example, my 27X came with a Miniscribe 8438
> kit from a refurbisher.
> Ryan Underwood, <nemesis at icequake.net>
There were lots of different controllers for the PC/XT. None were data
comptatable with the other.
The 238 came out later in the picture as far as the PC is concerned. But I
personally used at least three 8 bit RLL controllers (WD, Adaptec, and
Seagate) there were many others.
If you changed controllers you had to do a low level format.
If you have some different controllers you will need to do trial and error
to find the right one(s). I recomend write protecting the drives by either
cutting the write gate line in the cable or putting a piece of tape over the
It is also possible that the drives were both formatted MFM. The 225 & 238
were the same drive, I never knew of any real difference other than the
label. The MFM & RLL are different encode techniques, RLL requires a very
stable spindle speed beyond that required for MFM.
More information about the cctech