ard at p850ug1.demon.co.uk
Sat Mar 19 18:27:19 CST 2005
> Just spent the early afternoon trying to adjust my one working (out of 3)
> to print a decent imprint. New Ribbons, Clean Type Cylinder, Good Impact
> still just getting a very light (almost unreadable) character on the
A few thoughts in no particular order :
Isn't there a front-back platten adjustment affects print density
(particularly if the platten is too far back).
A new ribbon -- is it really NOS? -- could have dried out in storage
OK, if it's not those, then I'd check the print hammer carefully, In
particular, you want to check the spring tension, and strip down the
carriage and clean off any gummy lubricant. The hammer has to move freely
to give a good 'wack' to the sylinder.
More information about the cctech