PDP-11/05

[joseph c lang]

On Wednesday 02 August 2006 17:55, you wrote:
> > Sounds like you are describing the 11/05 10"  system unit.
> > It's a standard chassis. 11/05S IIRC
>
> I was under the impression that 11/05S refered to the later version of
> the CPU board set (which could end up in any mounting box). The main
> differences to the user being a couple of jumpers, one to disable the
> console port (allowing you to use a normal DL11 card for this), the other
> to diaable the bus arbitration, allowing the machine to be a slave
> processor on the Unibus of another machine (!)
>
> > It has a 1 rack unit panel below the front panel.
> > And a 3 rack unit panel above the front panel.
> > It has the power supplies along the right side (if you're facing the
> > front panel)
>
> Odd. The 5.25" box is like that, but the 10.5" one I saw had the PSUs
> across the back. It was the same box (BA11-K) as is normally used for the
> 11/34
>
> -tony

I'm willing to accept more than one version of the 10.5" chassis...

My 11/05 has the same power regulator as used in the 5' chassis 
along the right side and has a H744 behind that. 

I seem to recall seeing an 11/05 with h744s along the back as you describe.

joe lang