Fujitsu 2444 data rate setting (was Re: Pertec interface)

[Chuck Guzis]

On 1/12/2006 at 4:37 PM jim stephens wrote:

>I believe that page 4-52 of the manual, physical page 77 of the document
>describes the paramter P0 which is the buffer rate select.  It refers to
>"Section 10.7" to see how to set the paramters.  Unfortunately, there is
>only section 1 thru 6, plus appendicies A and B in the manual.  I would
>imagine that to be refering to a user manual.   I did not see that yet.

Hmmm, take a look at:

http://sunsolve.sun.com/handbook_pub/Systems/Sun3/TAPE_10_Fujitsu-M2444AC.ht
ml

And scroll down to the section titled " IFC NVRAM Configuration
Procedures".  Might the right-hand column of settings from P0-P7 have
something to do with this?

Cheers,
Chuck