Help with ICL power supply fault (Farnell SMPS)
Roy J. Tellason
rtellason at verizon.net
Thu Apr 10 17:16:21 CDT 2008
On Thursday 10 April 2008 17:28, Tony Duell wrote:
> > > I think it's reasonable to asusme the chopper is working (otherwise
> > > you=
> > 'd
> > > get no outputs at all). Does it seem to be running continuously, or do
> > > you get the 'tweet tweet tweet' of a PSU that's starting, detecting a
> > > fault, shutting down, and repearing?
> > Scoping tbings in there would sure be informative.
> The prolem is that if this is like most small SMPSUs, then almost all the
> 'interesting' circuitry (oscillator, etc) is on the mains side of the
> isolation barrier. And therefore you can't just connect a 'scope to it,
> not unless you like shorting out the mains via one of the rectifier
> diodes and the earth (ground) lead of the 'scope.
This is true, though at the time I wrote that I was thinking about scoping
> The right way to do it, of course, is to use an isolating transformer,
> but not everybody has one of those in the workshop. I certainly do not
> recomend 'floating the scope;' (removing its earth lead so the 'scope
> chassis can sit at half mains voltage, or whatever), even though this is
> suggested in one service manual I have if an isolating transformer is not
> avaialble. I have this objection to large metal ohjects sitting at
> dangerous voltages.
One way to achieve isolation is to get a couple of filament transformers that
are of similar voltage ratings and use them both, tying both low-voltage
windings together and using one primary as the output. I'd think that they
wouldn't need to be particularly hefty if you're not going to load the supply
Member of the toughest, meanest, deadliest, most unrelenting -- and
ablest -- form of life in this section of space, a critter that can
be killed but can't be tamed. --Robert A. Heinlein, "The Puppet Masters"
Information is more dangerous than cannon to a society ruled by lies. --James
More information about the cctech