VAXstation 3100 and DecWindows

[Rod Smallwood]

Very interesting but no reference to my problem I'm afraid.


I have gone back to the start, cleared the hard drive, installed VMS 7.3
and registered the license (choosing the right support files etc.) Then
I loaded the DW-MOTIF layered product and registered the license. In
both cases I followed the install instructions to the letter.

1. 	It does not come up or even attempt to come up in windows.

2.	If you run the IVP and enter the node name or WSA0 (the device
name)
      it simply says "cannot open display"

3.    I am exactly where I was on Friday. 

4.	Until I find out what "Cannot open display" means I'm stuck

Regards

Rod
-----Original Message-----
From: cctech-bounces at classiccmp.org
[mailto:cctech-bounces at classiccmp.org] On Behalf Of Chris H.
Sent: 20 April 2008 02:35
To: General Discussion: On-Topic and Off-Topic Posts
Subject: Re: VAXstation 3100 and DecWindows

2008/4/19, Rod Smallwood <RodSmallwood at mail.ediconsulting.co.uk>:
>  Now for my ultimate goal; load and run DECWindows. I ran the install 
> as  per the manual  (that's a book that tells you everything you don't

> need to know and  nothing that you do).

- http://icanhaz.com/decw_cookbook

(Maybe this could come in handy.)