OT: Pushing pins

[Eric Smith]

Chuck Guzis wrote:
> I can pop the pins out of 1/16" PCB using just a wirewrap bit, but 
> 1/8" OD tubing is *way* too thick to do the job on the 1/8" stock.  

I don't understand where the problem is.  The ID of the tubing has to be 
at least 36 mils to fit a 25 mil square WW tail.  The smallest I had on 
hand was 1/8" OD, and that fit just fine over the pins.  3/32" OD tubing 
might work.