[personal] Chip ID and datasheet?..

[Mike Hatch]

That chip, can't remember the style, had wider pins for heat sinking, some 
had 2 or 3 pins per side as one large tab for greater effect.
They can be a bugger to get off, hot air reflow seem to work better. Have 
used a paint stripping gun on low heat to good effect, but use care.
Other than that I've not been able to find any datasheets, not much help I'm 
afraid.

Mike.
>
> It looks like a normal DIP, except for the middle pins which
> look to be twice as wide.  Is this for heat sinking?  I have tried
> searching for this chip but so far have found nothing.  The board has
> this marking;
>
> PC-368C
> JAPAN SERVO
> TDK-T15V
>
> Which also has not turned up anything useful..  The 5 1/4"
> drive mech this board is connected to was made by Matsushita and its
> model # is JU-570-2.
>
> From reading the SFD-1001 technical manual, the 5 1/4"
> mech is just listed as a part so it does not have any detailed
> information for this board. :(
>
> Cheers,
>
> Bryan
>
>
>