Osborne OCC1 problem
javickers at solutionengineers.com
Sat May 17 08:47:18 CDT 2008
Tony Duell wrote:
> Hang on, are you saying you're getting 5.4V at the output of
> the PSU and 4.16V across the power and ground pins of a chip
> on the logic board?
I am, but I was wrong... I'd got the wrong pin; in fact, the voltage drop
(on the multimeter) is 0.1v (5.4v to 5.3v) when I use the "correct" GND pin.
And the chip is an F6821P, not an 8132 (I'd read the wrong number, and got
that wrong too... blame my flaky memory).
No virus found in this outgoing message.
Checked by AVG.
Version: 7.5.524 / Virus Database: 269.23.16/1448 - Release Date: 16/05/2008
More information about the cctech