OmniProm programmer

[Alexandre Souza]

    This one?
    http://resume.robert.weathergreen.com/projects/omni-1.htm

    Maybe the omnipro II program will work?
    http://www.dataman.com/Webpages/SoftwareDownloads.aspx?PN=Omni+Pro+II&SH=Omni+Pro+II&IAK=1

----- Original Message ----- 
From: "Jeff Jonas" <jeffj at panix.com>
To: "cctech" <cctech at classiccmp.org>
Sent: Sunday, November 02, 2008 8:32 PM
Subject: OmniProm programmer


> I'm trying to revive an EPROM programmer:
>
> the bottom label says
>  Omni-Prom Programmer
>  model OMNI-01
>
>  SherTek, Inc.
>  Memphis, TN USA
>
> but the inner label says
>  P/N OMNI05, V7.0, R0.0
>  (C) 1986, SherTek Inc.
>
> It has 28, 40 pin ZIF sockets on top,
> internal power supply.
> But the only interface is for the PC's parallel port
> so I'm unsure what protocol it uses
> to read back the results.
>
> I'm missing the floppy with OMNI.EXE
> the DOS program that ran it.
> The manual only documents the program menu,
> not the parallel port protocol.
>
> Any clues?
> -- jeffj at panix.com
>


--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.175 / Virus Database: 270.8.5/1763 - Release Date: 2/11/2008 
19:08