Dot Matrix head rebuild...Anadex and others.

[John Robertson]

Anyone have any info on rebuilding the head for a regular 9-pin dot 
matrix printer? I have an open pin-5 coil on mine, and I would like to 
take it apart to see if I can repair/replace the coil, BUT I am a bit 
concerned about taking these things apart. Springs flying off, etc.

Looking on-line does not turn up anything (so far) on dismantling these 
suckers. If necessary I will document it myself, but was hoping the info 
was already out there!

The head I have is an Anadex DPH-100, and the only place on-line that 
shows them no longer repairs 'em! Nor did the tech I spoke to recall any 
details...

John :-#)#