Need help with Project Northstar/Data I/O System-19/ADM Terminals (dwight elvey)

[Chuck Guzis]

On 22 Dec 2010 at 8:25, Robert J. Stevens wrote:

> My Latest attempt was to EDIT out a Intel Hex file to make it PURE
> Binary but that doesn't want to load properly either. I burnt a Prom
> with a few additional lines of Code that I had to shrink as it didn't
> match the input file when I load RAM from the device and created a File
> from it. But alas even that did not perform as it should on the N*. I
> could not see the OUT [6, 2, 3] instructions being executed the way the
> do with the Original 2708. If I go back to the 2708 that Andrew L Burnt
> for me the Code performs in accordance with the Listing. 

Won't good old MS-DOS DEBUG load an Intel .HEX file?  Once it's 
loaded, it's a very small deal to write it out as a pure binary file.

--Chuck