More SCSI Confusion

Rob Jarratt robert.jarratt at ntlworld.com
Tue Oct 19 05:20:24 CDT 2010


As far as I can tell, I only have a terminator module (behind slot 6), but
not a jumper module.

Regards

Rob

> -----Original Message-----
> From: cctalk-bounces at classiccmp.org [mailto:cctalk-
> bounces at classiccmp.org] On Behalf Of Adrian Graham
> Sent: 19 October 2010 10:24
> To: General Discussion: On-Topic and Off-Topic Posts
> Subject: Re: More SCSI Confusion
> 
> On 19 October 2010 00:13, Rob Jarratt <robert.jarratt at ntlworld.com> wrote:
> >> Rob
> >
> > I have confirmed that it is indeed working in split bus mode. It seems
> > I need a BA35X-MF jumper module to get it to work in single bus mode.
> >
> 
> That should be under the other fan, you normally just swap them over top
to
> bottom. If you look in the front of the enclosure you'll see a pin poking
> through near the top and bottom, I think they're marked 'T'
> and 'J'. This shows you which is currently the jumper and which is the
> terminator.
> 
> 
> --
> adrian/witchy
> Owner of Binary Dinosaurs, the UK's biggest home computer collection?
> www.binarydinosaurs.co.uk




More information about the cctech mailing list