Probs w. M3119 CXY08 MUX on VAX VMS 7.3
holm at freibergnet.de
Tue Aug 18 06:17:07 CDT 2015
Johnny Billquist wrote:
> On 2015-08-18 11:31, Holm Tiffe wrote:
> >Jerry Weiss wrote:
> >>Sorry if some of the suggestions aren?t appropriate, was just throwing a
> >>few things out.
> >>Can you post a sample of the output for one of the lines that has an
> >Error Log Report Generator Version V7.1
> >%ERF-F-INVQUAVA1, value 'TX' invalid for /INCLUDE qualifier
> >I've looked over what was reported with $analyze/error/since=yesterday/full
> >but haven't found anything interesting ..
> Not sure why /include=tx was suggested. I don't think that makes sense.
> Anyway, you found a way around that. Otherwise, the device name should
> be used, which should have been TT I believe.
> But I would expect there to be some information in the error log as your
> error count is non-zero. Strange...
> Things that would be interesting to check more is that you really have
> the right device type and driver installed.
I've pulled the card in the meantime and looked at the Qbus connectors
from the backplane using a lamp..they are looking nice (there lives a
really tiny spider in there, but I dont' think that it would hurt something
:-) No way to pull it out w/o dismantling the machine).
Now I have connected 5 Volts to the xtal oscillator at the pcb, unfortunately
it is ok also, 4,5Vss and the frequency is correct.
Now I'm resoldering the PLCC housed gate array on the board with hotair, but
I don't think that it would change anything, the soldering points are
looking good so far.
after that I will retest the board and looking again to the error log.
Please be patient..
Technik Service u. Handel Tiffe, www.tsht.de, Holm Tiffe,
Freiberger Straße 42, 09600 Oberschöna, USt-Id: DE253710583
www.tsht.de, info at tsht.de, Fax +49 3731 74200, Mobil: 0172 8790 741
More information about the cctech