Reproducing old machines with newer technology (Re: PDP-12 at the RICM)
paulkoning at comcast.net
Tue Jul 14 18:30:00 CDT 2015
> On Jul 14, 2015, at 4:41 PM, Chuck Guzis <cclist at sydex.com> wrote:
> On 07/14/2015 10:29 AM, Paul Koning wrote:
>> The accuracy of the FPGA depends on the approach. If it’s a
>> structural (gate level) model, it is as accurate as the schematics
>> you’re working from. And as I mentioned, that accuracy is quite
>> good; it lets you see obscure details that are not documented and
>> certainly not visible in a software simulator. The example I like to
>> point to is the 6000 property that you can figure out a PPU 0 hard
>> loop by doing a deadstart dump and looking for an unexpected zero in
>> the instruction area: deadstart writes a zero where the P register
>> points at that time. But you won’t find that documented or explained
>> anywhere. The FPGA model derived from the schematics reproduces this
>> behavior, and when you look at how it happens, the explanation
>> becomes blindingly obvious. *This* is why I feel there’s a point in
>> doing this sort of work.
> I can agree with some points, but not others. In the 6600, for example, clock distribution was a big design issue--not so in an FPGA. You had racks of taper-pin mats of wiring between the cordwood moules extending over (by today's standards) long distances. Cooling was a huge issue. In those respects, an FPGA hardly resembles a "real" 6600.
Certainly, the physical aspects are completely different. And clock distribution, certainly. Not so much between chassis, interestingly enough, but throughout the logic within a chassis. And wire delays in chassis to chassis cabling are very significant. Wire delays within the chassis, in a few cases, but 99% of the wires are short enough that their delay is not a real consideration in comparison with the logic circuit stage delay.
The example I gave, and others like it, are properties of the detailed logic design, they are not dependent on the details of the timing closure, or the physical design of the machine.
More information about the cctech