Troubleshooting a N* Advantage

Steven Hirsch snhirsch at gmail.com
Sat Jun 6 12:31:20 CDT 2015


My Advantage decided to stop booting from floppy disks (the only media it 
is capable of booting).  At first it threw random disk errors, then 
progressed to the point where I get an immediate "Hardware Failure" 
diagnostic on screen at power up.  If I reset and hit 'Enter' it starts 
the disk drive comes right back with a "?" prompt and LOAD SYSTEM.

I've checked the obvious:

- Power supply voltages are good
- Pulled, cleaned leads and re-seated 52 very tarnished 4116s
- Cleaned and reseated all other socketed parts.

A lot does seem to be working.  Display is fine.  I can enter the 
mini-monitor and poke around.  Keyboard is being read properly.

I accidentally found an undocumented diagnostic (enter mini-monitor with 
Ctrl-C and enter 'A').  This displays the disk controller status 
registers.  The only activity is the sector mark pulse, so something is 
responding to disk data.

Any advice from other Advantage owners or those familiar with the beast 
would be appreciated.

Interesting data point:  I replaced the 8035 slave processor with a newer 
8035 from the parts bin and none of the I/O operations it manages worked 
at all - no keyboard no disk activity.  Is there perhaps something special 
about the older part?  I'm not aware of any major differences in this part 
through the years, but you never know.



-- 


More information about the cctech mailing list