PDP-12 Restoration at the RICM

Mark J. Blair nf6x at nf6x.net
Sun Jun 14 10:00:13 CDT 2015


> On Jun 14, 2015, at 06:53, Michael Thompson <michael.99.thompson at gmail.com> wrote:
> 
> Dave Tumey sent us a new rubber hammer for the Teletype. This is the part
> that pushes the print drum against the ribbon and paper to print. These are
> newly molded parts that have not been available for decades. Works very
> nicely.

I should order one, too. I'm presently using the rubber tubing over the hammer kludge.

> The donor dropped off the work table that goes in front of the PDP-12. We
> need to loosen the rusted feet so it will fit under the front panel.

That sounds like a good excuse for more pictures!

-- 
Mark J. Blair, NF6X <nf6x at nf6x.net>
http://www.nf6x.net/



More information about the cctech mailing list