First VAX-11/730 VMS Boot! (was: Re: VAX-11/730 %BOOT-F-Unexpected Machine Check)

Mark J. Blair nf6x at nf6x.net
Sun Jun 14 12:25:07 CDT 2015


> On Jun 14, 2015, at 10:01, tony duell <ard at p850ug1.demon.co.uk> wrote:
> 
> If the connector on the DELUA board is a normal Berg-type header (and I think it is) then maybe you could
> use a piece of (twist-n-flat?) ribbon cable to make an extension that could be routed through the cable
> pan arrangement and then connected to the original DELUA cable back in the rack cabinet.

That might be a good approach. The DELUA end of the cable has a Berg connector, and the other end has the typical 15-pin D-sub AUI connector with a slide latch. I'll look up the cable wiring to see if signals that would best be twisted pairs are conveniently placed on adjacent odd/even pins, such that twisted pair ribbon cable would work well electrically.

Or maybe I can use the round cable that I already have, with P-shaped cable clamps screwed down using the screws at one end of the flat cable clamps. There may not be enough clearance in the tray for that.


-- 
Mark J. Blair, NF6X <nf6x at nf6x.net>
http://www.nf6x.net/



More information about the cctech mailing list