HP-85A tape drive conversion
coryheisterkamp at gmail.com
Tue Mar 31 17:23:27 CDT 2015
If the original dimensions can be ascertained, you might try JJ Short. They've done both a Flexowriter power roll and an IBM Executive platen for me with fresh rubber of the correct durometer. It's worth an inquiry, at least - Cory
On Mar 31, 2015, at 4:03 PM, Rik Bos wrote:
> You shouldn't under estimate the force on the capstan.
> I'm also not a fan of shrink tube, the it's to smooth and not durable.
> I've experimented a lot when figuring out how to make the QUICK40
> modification (after I knew it was possible because Larry Afferton was
> selling QUICK 40 HP-85's).
> I found the best way to refurbish the rollers was using small rubber sleeves
> and grind them to the right size. The sleeves are glued to the capstan and
> have much more friction than shrink tubes. Which results in less jitter and
> a better and more constant tape transport. The exact measures of the capstan
> can be found at hp9845.net : http://hp9845.net/9845/tutorials/tapedrives/
>> -----Oorspronkelijk bericht-----
>> Van: cctalk [mailto:cctalk-bounces at classiccmp.org] Namens Smith, Wayne
>> Verzonden: dinsdag 31 maart 2015 21:21
>> Aan: cctalk at classiccmp.org
>> Onderwerp: RE: HP-85A tape drive conversion
>>> Date: Tue, 31 Mar 2015 06:20:04 -0500
>>> From: "Jay West" <jwest at classiccmp.org>
>>> So. two questions: What SHOULD the outer diameter of a good capstan
>>> roller be on that drive, and does anyone have other suggestions for
>>> how to make the capstan roller "taller"?
>> I would try gluing an extender piece on the end of the existing capstan
>> perhaps using wood which is easy to shape. Once you wrap it with a piece
>> two of heat shrink tubing, I would think that it would all stay in place.
More information about the cctech