High performance coprocessor boards of the 80s and 90s - was Re: SGI ONYX
rdawson16 at hotmail.com
Fri Apr 22 03:10:13 CDT 2016
I had a similar board set for CAD, wish I still had it. It was two boards, a 68000 and a graphics board, to run VERSACAD.
In the CAD wars against AUTOCAD, we were winning for a bit, I was a rep selling this 3D solution.
It was Sun3 boot, and ran the Sun version of VERSACAD.
From: cctalk <cctalk-bounces at classiccmp.org> on behalf of Michael Holley <swtpc6800 at comcast.net>
Sent: Thursday, April 21, 2016 9:57 PM
To: 'General Discussion: On-Topic and Off-Topic Posts'
Subject: RE: High performance coprocessor boards of the 80s and 90s - was Re: SGI ONYX
I worked for the FutureNet division of Data I/O in the late 1980s. One disastrous product was a UNIX based coprocessor system that plugged into an IBM PC/AT. The idea was to run circuit board layout software and simulation on a PC. This would be less expensive than the Daisy, Mentor, or Valid workstations. The coprocessor was an Opus plug in board based on the National 32032 CPU.
When you ordered the package you got the coprocessor board and a 5 MB hard drive loaded with UNIX and the design software. On a good day the system worked. It was discontinued when PCs with the 368 processor were available.
More information about the cctech