Anyone have a spare PDP-11/84 serial console panel they could part with?
Jerome H. Fine
jhfinedp3k at compsys.to
Tue Jul 26 09:11:53 CDT 2016
>On Tuesday, July 26th, 2016 at 0:05:48 -0500, Glen Slick wrote:
>I just acquired a PDP-11/84 that didn't come with a console panel.
>That should have a 25-pin D-shell connector for the console serial
>port, a baud rate selection switch, and a forced dialog switch, with a
>single 20-pin connector for a ribbon cable that attaches to the
>KDJ11-B and MDM. The part number should be 54-16508-01 according to
>the manuals I have seen, although the only hits I find online have it
>transposed as 54-16058-01.
I am probably wrong, but the part number on the cabinet kit for the
serial port with the 25-pin D-shell connector for the PDP-11/83
that I have is 54-16023. About 1/2" to the right is a second
number 54-16022-01C1. These numbers are on the solder side
of the PCB board. Also stamped on this board in ink is the number
7021150-02-Rev A1. In addition, there are TWO ribbon cables
which connect to the quad board, a 20-pin cable AND a 10-pin
cable. I may have another cabinet kit somewhere that looks the
same at first glance, but has different part numbers. If I find it,
I will reply with those numbers.
As far as I can remember, all of the quad PDP-11/73 and PDP-11/83
CPU boards use the same cabinet kit since the only differences between
the two boards is the J11 chip version and the clock crystal which
supports running the PDP-11/83 board at 18 GHz rather than 15 GHz
for the PDP-11/73 with an older version of the J11 chip that had a
problem with floating point when run at the higher speed.
Finally, since the quad CPU board for the PDP-11/83 is the identical
board used in the PDP-11/84, I would expect that the same cabinet
kit would be used for both systems, but naturally I could be wrong.
>If you have one available let me know offline in private email how
>much you would want for one. I'm located in the Seattle, WA area.
If you can't find a cabinet kit somewhere, let ne know in a few weeks
and I will look to see if I can find the second one. I am in Toronto,
so shipping would be much more expensive outside the USA.
More information about the cctech