TU58 yet one more time.
pbirkel at gmail.com
Sun May 29 15:06:01 CDT 2016
From: cctalk [mailto:cctalk-bounces at classiccmp.org] On Behalf Of Al Kossow
Sent: Sunday, May 29, 2016 3:00 PM
To: cctalk at classiccmp.org
Subject: Re: TU58 yet one more time.
On 5/29/16 11:34 AM, Mark J. Blair wrote:
> My first attempt to use silicone tubing to repair my TU58 rollers was also
unsuccessful. Maybe the material I used is too soft? Your experience
suggests to me that I should hook up an oscilloscope to measure bit timing,
and then adjust the roller composition and diameter to arrive close to the
correct bit length.
dug this up from the cctlk archive
It just says "norprene A-60-F" the outside. It measures 3/8" I.D.
I think other's have said 7/16" i.d., but I could not find that. I know I
bought it from US Plastics and it's A-60-F.
You have to buy 10' but its not very expensive.
"A-60-F" would be here?
http://www.usplastic.com/catalog/item.aspx?itemid=23886 $26.95 for 10 foot
3/8" ID x 5/8" OD x 1/8" Wall TygonR A-60-F Hot Food & Beverage Tubing
More information about the cctech