Model M case screws

Chuck Guzis cclist at
Sun Jul 2 12:48:10 CDT 2017

On 07/02/2017 09:45 AM, Chris Pye wrote:

> Chuck, dare may I ask what you were doing with electricians pliers that close to a pneumatic cylinder?

It was on a test-bench setup.   Part of my job back then was calibrating
the stroke of cylinders to the 3-15 psi control signal.  Plant air
(power supply for the cylinder) was around 50 psi, IIRC.

Just one of those things, where you forget where you left things.  Of
course, nowadays, more than a half-century later, I forget where I leave
my keys, glasses, wife, etc.   So it's not something that's remedied
with age...

Indeed, lately I seem to be suffering increasingly with the "where did I
put that?" problem, even if the "when" was only a few minutes earlier.


More information about the cctech mailing list