north at alum.mit.edu
Wed Mar 22 19:15:37 CDT 2017
On 3/22/2017 5:03 PM, Don North wrote:
> On 3/22/2017 4:25 PM, Bill Gunshannon wrote:
>> Look here: http://www.vcfed.org/forum/blog.php?12663-AK6DN for info on my
>> Arduino based RX02 emulator using a microSD card.
>> Works on RX11/RXV11/RX8E as RX01, RX211/RXV21/RX28 as RX02. Passes DEC
>> hardware diagnostics.
>> Reinhard has done an FPGA based RL01/2 drive emulator, see:
>> aka AK6DN
>> I saw that. I ordered a set of boards from OSHPark today. Once they come I
>> will see about ordering the
>> parts and building at least one. I may wish I had more controillers. :-)
>> I will take a look at the FPGA solution. But I still have to ask, is there
>> any reason why it could not be done
>> with an Arduimo like the RX emulator? I haven't researched it deeply, but I
>> never thought the RL drive
>> itnerface was all that complex.
> If you are still interested I still have blank PCBs for $10 each (either 2n7K
> or 8641 based), plus Sparkfun microSD adapters $5 ea, and then shipping.
> OSHpark is good (I use them for proto) but it will cost you something like $75
> for three boards since they are 4 layer. Let me know if you are interested.
> The RL0x interface is very different and requires some kind of high speed
> signal decoder to implement (Reinhard did it in an FPGA plus an embedded CPU).
> The RX0x interface is driven by the drive as the master, so no high speed
> logic is required on the Arduino side, just bit banging I/O ports.
Just checked my stock ... I have (5) 8641 based PCB, and (10) 2n7k based PCB
left, and corresponding microSD adapters.
The 2n7K vs 8641 designs are functionally compatible (100% same software); the
revised 2n7K design uses discrete transistor O.C. drivers and
HCT14 RCVRs in place of the 3x8641 (which are more or less unobtanium at this
point, unless you have a well stocked DEC stockroom).
The two designs work the same, there is no discernible difference between them
As an aside I source Arduino Mega2560s from Amazon, you can get 100% a 100%
compatible clone for $10-$12 vs $45 for a 'genuine' Arduino Mega2560.
More information about the cctech