RL02 Question

Aaron Jackson aaron at aaronsplace.co.uk
Tue Mar 27 16:04:49 CDT 2018


>>>>>> So, from what I can see, the drive should spin up correctly, but for
>>>>>> some reason it goes into fault mode. I am right in thinking that upon
>>>>>> load, the heads should continue moving forward until the first track is
>>>>>> found, right? I should not have to perform a seek manually from the PDP?
>>>>>> If this is not the case, perhaps there is something else wrong.
>>>>> I’m not an RL02 hardware expert at all, just a daily user back in the
>>>>> day. I’m reading this assuming that at all times the drive is
>>>>> correctly hooked up to an RLV12 in a running PDP with the correct
>>>>> cable and termination present on the drive? If it isn’t you’ll get a
>>>>> fault condition instead of ready after spin up.
>>>>>
>>>>> A
>>>> No worries, your input has been valuable, so thank you.
>>>>
>>>> For anyone else who might have an idea:
>>> ON fault the heads are retracted and will not load till cleared.
>>> Least mine behaves that way.
>>>
>>> Most common problems are wrong drive address, cable issues, no terminator.
>>> Others include head lock not removed or the auto unlock style of
>>> headlock has
>>> the tab broken.
>>>
>>>> It seems to be hooked up correctly. When it is in the weird flashing
>>>> ready state, the boot loader says "Read error" or "Device error"
>>>> randomly. The heads oscillate back and forth very slightly as if it is
>>>> trying to align itself better on the first track, which doesn't exist
>>>> because it hasn't moved far enough into the pack.
>>> IF in fault its resetting to retracted on every try.
>>> If not something else is wrong.
>>>
>>>> I'm beginning to think the heads are bad which will be far too expensive
>>>> so I may end up giving up.
>>> Heads are not that expensive... However you could have a wrong pack
>>> or one that has been erased and has no servo tracks. You must start with
>>> a known good pack and cleaned heads.
>>>
>>>
>>> Allison
>> Well, I replaced the DOWN head and adjusted the amplitude on the r/w
>> board. The drive now stays in READY without the FAULT lamp coming on, so
>> this is promising. The heads load onto the first track.
>>
>> Without any r/w operations, should the READY light flash? Mine is
>> flashing a little but not too rapidly. I am guessing this is while it
>> tries to keep the heads positioned over the track.
> Yes, normal read/write/seek activity causes that.
>
>> When I try to boot using the MXV11-BF boot roms, it says:
>>
> MXV-11 boot is not very chatty or informative.
>
>> ]] ?BOOTROM-F- DL 0 read error
>>
>> The alignment between the two heads looks okay also.
>>
>> Any ideas, anyone?
>
> Is the OS on it? IF RT-11 is it configured to boot from DL-nn?
> IF you have OS on floppy can your do a dir of the devices it knows of?
>

This occurred to me just after I last replied. Silly me. Ended up
booting into 2.11BSD to see if I could run disklabel on it. No such
luck. I'll try RT-11 later this week. If that doesn't work I'll boot
into XXDP over TU58 and give that ago.

Thanks very much for your help, Allison, and others.

Best,
Aaron.


More information about the cctech mailing list