Mounting HP7970e 9-Trk 1/2" Tape Drive
cclist at sydex.com
Mon Feb 11 12:08:38 CST 2019
On 2/11/19 9:16 AM, Fred Cisin via cctalk wrote:
> A few hundred pounds slid all the way out will topple it.
> If the center of gravity is NOT within the perimeter of the base, . . .
> Need to bolt the rear to the floor, or something SOLID, and extend the
> "footprint" of the front to include where the center of gravity is when
> fully extended. And a bit more, so that setting a tool or elbow on it
> doesn't topple it.
That's one of the reasons that a lot of computer racks have an
"anti-tip" slideout on the bottom. It should be pretty simple to
fabricate one, if you're handy with a welder. Basically, just some
square tube stock fashioned into a "T". It'd let you keep the casters
on the bottom of the rack.
More information about the cctech