PDP-11/45 RSTS/E boot problem

Paul Koning paulkoning at comcast.net
Mon Jan 28 08:50:32 CST 2019



> On Jan 27, 2019, at 9:27 PM, Fritz Mueller via cctalk <cctalk at classiccmp.org> wrote:
> 
> 
>> On Jan 27, 2019, at 3:06 PM, Fritz Mueller <fritzm at fritzm.org> wrote:
>> 
>> I'll keep you posted about what I find out from ANALYS!
> 
> Posted below.  I've elided the core dump here so not to spam everybody; will send off-list.
> 
> Note that I only copied over the blocks of [0,1]CRASH.SYS, and overlaid them on a copy of the disk image that I already had on my machine, then booted that under SIMH to run ANALYS.  Is copying over [0,1]CRASH.SYS enough, or need I take the time to image the entire disk after the dump?

Just the crash file.  However...


> 
> ========================================================
> 
> ANALYS  V06C-03 RSTS V06C-03 FRITZTS
> Input <[0,1]CRASH.SYS>? 
> Output <KB:ANALYS.DMP>? 
> Crash Error Log Filename <$ERRCRS.FIL>? 
> 
> Analysis of (0,1)CRASH.SYS/SIL:SY0:(0,1)RSTS.SIL
>        Taken on 27-Jan-89 at 06:16 PM
> 
> 
> Certain Critical values are inaccurate
> Octal Dump of Status will not be attempted

That's puzzling.  How did you generate the crash dump?  I remember that message but not what causes it (if I ever knew).

Perhaps it wants to read the defaults.  If so, copying the monitor SIL file would take care of that.

Is the system on which you're running this ANALYS run using the same monitor as the failed system?  Maybe that's the issue.  If ANALYS is using current monitor offsets to find data structures in the dump file, that won't work if you're analyzing a dump from a different system.

	paul



More information about the cctech mailing list