Circuit board trace repair...

Jon Elson elson at
Mon Aug 10 17:04:45 CDT 2020

On 08/10/2020 04:31 PM, William Sudbrink via cctalk wrote:
> Hi All,
> I'm going to be attempting to repair, both cosmetically and operationally, a
> circuit board that had a strip of 12 volt trace "blown off" of it by a
> short.  The fiberglass is clean and there was no solder resist in the
> affected area.  I'm considering using 3M 1183 adhesive tinned foil tape for
> the job.  Has anyone else done this?  Could you recommend this or another
> product?  Any tips?
I usually repair these with solid copper wire, but then I'm 
not trying to make it cosmetic, too.


More information about the cctech mailing list