test-drb

test-drb@ccmp.vtda.org

101090 discussions

by dkgrizzly＠thewaffleiron.net

I have a BA23 chassis that was used to hold 3 DSSI disks. There was a different backplane with the load resistors instead of QBUS slots. There was also a large capacitor bank installed along side the DSSI disk in the place of the QBUS slots. I can dig around next week when I go back home if you still need the resistor sizes DEC used. -David Kuder

7 years, 2 months

Missing posts in archive and no Subject: line

by jnc＠mercury.lcs.mit.edu

> From: Joe Zatarski joezatarski at gmail.com > The posts you mentioned were sent to cctech. .. that list is > moderated .. You'll notice these posts are now in both archives. Ah, that could be it. I thought I'd found them in the Subject: thread archive at the same time they weren't in the other, but maybe my memory is faulty. > From: Eric Christopherson > the reply to the message headed "No subject" .. actually seems to > have a blank subject, as a result of which it doesn't seem to be > possible to even view it (since there's no link to click)! Which is how I discovered those messages which weren't (yet) in the archive; I took the URL for the previous message, edited it to point to the next message, and discovered the 'missing' ones. (Apparently the list software makes messages available via the Web interface before they've been approved and added to the archive.) > John H. Reinhardt > And now I know why your posts always break the threading in > Thunderbird... Hey,I don't want my emailbox clogged up with this stuff! :-) Noel

7 years, 2 months

vaxstation ii machine check & diags efficacy

by bear＠typewritten.org

It's a VAXstation II/GPX. I'm trying to install VMS 5.5 (from CD if it matters; there is a CMD CQD-200 or -220 as the only storage controller) and routinely getting machine check exceptions. Standalone backup always boots. Sometimes I get an exception the moment I hit <enter> on a restore; sometimes in the middle of the restore, sometimes it runs to successful completion. VMS never boots. Sometimes I get as far as the date prompt (I took out the battery), sometimes it gets a little farther, frequently it's before anything appears on the console at all. The exceptions booting VMS occur the same if I attach another disk with VMS 5.5 already installed; if I replace the KA630 and M7609 with a KA655 and M7622, it all seems to run fine. The KA630 power-on diagnostics all pass, but... it smells like a memory fault to me. What are the odds there could be a memory fault that isn't caught by the diags? ok bear. -- until further notice

7 years, 2 months

PDP 11/15

by jnc＠mercury.lcs.mit.edu

> From: Bob Smith > there have been refs to another more modern unit, based on LSI[-]11 > or later chip set I've never heard of that, and I wonder if DEC would really have released a new product with the same name as an old one (the two PDP-11/10's are different, as I'm not sure many of the first ones were sold, but a ton of -11/15's were). > I wonder if it is one of those or the orig. This one is one of the -11/20 type ones. > From: Paul Koning > I only ever heard of an 11/15 as the 11/20 relabeled for OEM > markets According to the "pdp11/15/20/r20 processor handbook", 1972 edition (i.e. the second edition of the -11/20 proc handbook), the /15 has (table on pg. 2) a "KC11" processor, which seems to be a KA11 with only a single interrupt request line. (Maybe it has a replacement card for the M824, with only a single interrupt line wired up?) There's a 'KF11-A' option which upgrades it to multi-line (pg. 4), for which there claims to be a manual (DEC-11-HKFA-D), but there are none online, but from other traces online it does seem that some people had to get and install it. So maybe the stuff in the proc manual isn't just marketing wibble. That same manual claims that power-fail restart was standard in the KA11; it was an option for the KC11, the KP11-A. Noel

7 years, 2 months

Teletype 5620 schematics

by aek＠bitsavers.org

came across these this eve, probably only of interest to Seth, since he has one http://bitsavers.org/pdf/att/5620/schematic

7 years, 2 months

Wanting to get my first classic computer

by jnc＠mercury.lcs.mit.edu

> From: Ray Jewhurst > I would really like to get my own classic computer but I don't know > where to begin. Two questions you need to sort out in your mind, to decide, are i) do you want something with a bit-mapped video screen, or are you happy with ASCII serial line only, and ii) what are you prepared to do for mass storage. E.g. if you really want video, you're probably looking at something like a VAXStation or so; if ASCII will do you, a QBUS PDP-11 might be a good start, as with patience eBay can yield a cheap chassis, CPU etc (although in the last year or so the really cheap stuff seems to have dried up, alas). Noel

7 years, 2 months

CC users in Ireland

by ronan.scaife＠dcu.ie

Dear All, At 03:30 PM 17/06/2019 +0100, Ronan Scaife wrote: > Dear All, > > I am particularly interested to make contact with Ireland-based > classic computer collectors or users. on 18 June 2019, Guy Dunphy wrote: > Message: 8 Date: Tue, 18 Jun 2019 09:34:11 +1000 From: Guy Dunphy > <guykd at optusnet.com.au> To: ronan.scaife at dcu.ie, "General Discussion: > On-Topic and Off-Topic Posts" <cctalk at classiccmp.org> Subject: Re: > irish cctech subscribers Message-ID: > <3.0.6.32.20190618093411.011eaad8 at mail.optusnet.com.au> Content-Type: > text/plain; charset="us-ascii" Hi Ronan, I know you meant 'in > Ireland.' But I can't resist: I'm of Irish ancestry, though born and > residing in Sydney Australia. Also "My particular interest is in DEC > pdp-8 and pdp11 machines." Never thought I'd actually have any, until > unexpected events of 2018 and ongoing. Now so far I have two PDP-8/S > to restore ( http://everist.org/NobLog/20181104_PDP-8S.htm ) and two > PDP-11: Rack 1: PDP 11/44 and one RLO2 diskpack drive. Rack 2: PDP > 11/34, two RLO2 diskpack drives, and one RK05 disk pack drive. Seems > to be a complete, intact system. I have the side panels, various > blanking panels, and assorted documentation. Still making arrangements > for a long-term space to set them up and work on them. Regards, Guy > Dunphy >> My particular interest is in DEC pdp-8 and pdp11 machines. Dear Guy, good to hear from you! My interest stems from the generosity of DEC Galway, Ireland, who helped start my (DSP, speech) research career in the early 1980s with a generous donation of 2x 11/34s with RL02 and RX02. I also have a MINC (laboratory instrumented 11/23) from Trinity College Dublin. Quite recently, we acquired a pdp8/e (made in Galway) with RK05 and PC04 >from Dundalk Institute of Technology. I haven't dared to power this up, but a few of my students have worked on a replica pdp8/e front panel patched into a simh emulation on a PC. I look forward to reading your blog. My medium term plan is to interest the National Museum or equivalent in a section on (especially Irish-made) technology, so the email was primarily addressed to people on the island of Ireland. However, most of what I have learned over the years has been from guys around the world like you who are so generous with their information. Best Wishes, Ronan Scaife -- -- * *S?anadh R?omhphoist/Email Disclaimer* *T? an r?omhphost seo agus aon chomhad a sheoltar leis faoi r?n agus is lena ?s?id ag an seola? agus sin amh?in ?. Is f?idir tuilleadh a l?amh anseo.? <https://sites.google.com/view/seanadh-riomhphoist>* *This e-mail and any files transmitted with it are confidential and are intended solely for use by the addressee. Read more here. <https://sites.google.com/view/dcu-email-disclaimer>* * -- <https://www.facebook.com/DCU/> <https://twitter.com/DublinCityUni> <https://www.linkedin.com/company/dublin-city-university> <https://www.instagram.com/dublincityuniversity/?hl=en> <https://www.youtube.com/user/DublinCityUniversity>

7 years, 2 months

Whose site is 9track.net?

by cctalk＠snarc.net

Does anyone know who owns 9track.net? I couldn't find any contact information there.

7 years, 2 months

Looking for a Intel multibus 88/45... (minor corrections...)

by lbickley＠bickleywest.com

I'm in the process of restoring an Intel 310 system. I had it working to the point where it was trying to boot - when the 88/45 processor began to fail intermittently and then solidly. My debugging seems to indicate that the problem is in a PLD - which is a serious bummer. I have preserved the ROMS (which have built-in diagnostics/debugging and boot capability for both floppy and Winchester hard disks) as files. I will make these ROM files available to Al for posting on bitsavers. If someone on this list has an Intel 88/45 (or Intel 310) who would be willing to part with it, please contact me off list. I can to either do a trade or cash purchase... Cheers, Lyle -- 73 NM6Y Bickley Consulting West Inc. https://bickleywest.com "Black holes are where God is dividing by zero"

7 years, 2 months

Two AT&T Unix PC/3B1/7300 systems available

by nospam212-cctalk＠yahoo.com

I have two AT&T Unix PCs that I am offering up to interested parties as described below: 1) AT&T Unix PC with the standard 67 MB HDD, this is the base system and three button mouse. The right arrow key on the keyboard is broken but the key cap is still included. This unit is also missing the keyboard cable though I should have it around somewhere and so it might turn up at some point at which time I'd send it along. It has been several years since this was last powered on and I don't recall if there are any passwords or what they might be so you may have to hack your way into the system. Had UNIX System V installed but don't recall what other software may be installed as well. Sold as is. 2) AT&T Unix PC. This unit comes in the original box, with keyboard and mouse and the following documentation: a) AT&T Unix PC Owner's Manual b) AT&T Unix PC Getting Started Manual c) AT&T Unix System V Utilities Manual d) AT&T Unix PC Communications Management Manual e) AT&T Unit PC System Software As with the above system, it has been a while since it was last powered up and I don't recall if there were any passwords or what so may need to hack into the OS. Also not sure what software was installed besides the OS. Sold as is. I believe I may have some more documentation around but haven't located it yet, if I do discover it I will offer to send it along to anyone who picks up these systems. If you need any other info please let me know and I'll send it along. Will entertain any offers at all and prefer local pickup but I am fine with packing and shipping if you pay for it. I'm offering them up to the list first though if there isn't any interest here will possibly offer on eBay or if someone knows other good places to list systems please let me know. Would like to move them out. Will also have several other systems for sale/trade/haul away very soon as I am clearing out a lot of stuff. Best regards, David Williams

7 years, 2 months

Jump to page:

2026

2025

2024

2023

2022

2021

2020

2019

2018

2017

2016

2015

2014

2013

2012

2011

2010

2009

2008

2007

2006

2005

2004

2003

2002

2001

2000

1999

1998

1997

test-drb