18 Jun
2018
18 Jun
'18
1:44 p.m.
I'd seen your posts earlier, as luck would have it I've also been going
through some QIC tapes lately. I've been working with a US-based custom
rubber products manufacturer on finding replacement drive bands. Nothing to
report back yet, first round of samples felt like the right material but
were the wrong size (my goof, I think).
Thanks,
Jonathan
On Thu, Jun 14, 2018 at 4:26 PM, jacob--- via cctalk <cctalk at classiccmp.org>
wrote:
On Mon, 4 Jun 2018, AJ Palmgren via cctalk wrote:
If anyone is interested, I just published a few videos showing my testing
of PlastiBands for QIC Tape Cartridge
replacement.
https://youtu.be/irOrR-ZYwjw
and
https://youtu.be/GVsYHLvCvZY
A special thank you to CuriousMarc, Al Kossow, and Chuck(G) for their
help,
leadership and inspiration in this area!
And my page dedicated to QIC Tension Bands...
http://qicreader.blogspot.com/p/drive-belts.html
As always, I welcome feedback, and hope this is of value to some here.
Have just been through 25 qic tapes of amiga bbs backups , after 23 years
of being stored in a attic, the majority of tapes was in good order, only 3
had bad tension band.
A single 3M had lost all tension,causing slipping, and had gotten tangled
up, turned out to the the hardest of the lot to read, after replacing
the band and untangling it.
Your site was really helpful, had my doubt but your videos showed it wasnt
that hard after all to replace and untangle those tapes.
Restored 1.7gb data, mix of diavolo backup and amiback2 from two differnt
amiga bbs .
--
Jacob Dahl Pind | telefisk.org | fidonet 2:230/38.8