25 Mar
2016
25 Mar
'16
6:24 a.m.
-----Original Message-----
From: cctalk [mailto:cctalk-bounces at classiccmp.org] On Behalf Of tony
duell
Sent: 25 March 2016 12:59
To: General Discussion: On-Topic and Off-Topic Posts
<cctalk at classiccmp.org>
Subject: RE: Olivetti M24 Mounting Bushes for Bus Converter
Could you turn them on a lathe. I assume they're quite small.
-tony
=
Perhaps, if I had a lathe. I do have a locksmith friend who could possibly
make them, but it is the way they go into the base that is problematic. I
will have to post some pictures.
Regards
Rob
Could
they be 3d printed? Pictures might help...
There are actually two varieties. The plastic ones probably could, but
actually I was talking about the steel ones which probably can't. I
have put it all away again for now so I can't get any pictures right
now. I'll get it out again later, if I can, and post some pics.